OSDYLS - Open Source DIY Lasertag System #5

Okay here it is, one of the S2 mini, I ordered a batch of ten already. Yes I am positive about getting this done ;-) If not, it is possible to make a lot of other neat things with these little fellas.

However I figured that I need a smaller soldering iron for this one, already ordered too.



Meanwhile I did some research about the HC-12 radio modules. They have a quite long range but unfortunately it is not allowed to run them at max power here in germany.

However Wolfgang Ewald wrote a pretty detailed description in his blog "Wolles Elektronikkiste" on how to get these things in a legal mode while still achieving distances over 100m so I won´t get deeper into detail since I am not an electronics specialist. 

At the final version I´ll just note down what I made and what components I connected how and why. For detailed specifications check Wolles blog, though it is in german ;-)


Comments

Post a Comment

Popular posts from this blog

OSDYLS - Open Source DIY Lasertag System #7 IR communication

Image
Alright, this post is about the most important thing about OSDYLS, the IR communication. Before I started this I already bought a bunch of IR diodes and receivers that other people recommended in their attempts or just looked logical to me. Meanwhile I believe this is the part where most of the DIY attempts got stuck. Lets go through these projects: Pewduino There was much time and energy spent on this project, including own PCB and more, my deepest respect! Luckily today, due to the availability a lot of *duino electronics, noone has to reinvent anything anymore. He somewhere wrote he would go for a 50mm lens . Reason: focal length.  If you have a look at all these shopable lasertag toys you will notice a pretty small lens and IMHO there is a reason for this. If you start with a big lens you are able to transport more light to the target. True but it also starts with a bigger diameter and will end up in an even wider diameter at the target. I don´t see any advantage but I might be wro
Read more

OSDYLS - Open Source DIY Lasertag System #6 testing all components with the S2 mini

Image
With all (hopefully) collected components I am going to start with getting those to work with the S2 mini as I haven´t worked with that before. It behaves slightly different to the D1 when uploading the code but after reinstalling my Arduino IDE everything is good to go: 1. WLED 2812B strip for status indication  This is IMHO the simplest way to add some nice hit or being hit status to the tagger, in addition to the small OLED display, and it is up to everybody how many LEDs will be used. I will use only 3 as it keeps the power consumption low but already allows sort of animations. These strips usually draw about 0.06A / RGB when they are at 100% brightness and they (surprise!) do work with 3.3V just fine even if they are rated for 5V. So that would be a max of 0,6W for them.   As you can see I got myself the fritzing tool since it will come in handy to save the circuits to some sort of external memory plus if I decide to use some PCB service at the end to produce a small amount of boa
Read more